Radwin 2000 - Page 116

RADWIN2000UserManual Release2.8.30 6‐25
Installation
Figure6‐26:TDMJitterBufferConfiguration
Note
• Thereceiverjitterbufferforeachsitecanbeenlarged,
therebyincreasingsystemresistancetointerference(the
largerthejitterbuffer,thelongertheinterferenceperiod
thatthesystemwillovercomewithoutTDMerrors).
• Youcanalsodecreasethejitterbuffertodecreasethesystem
delay.
• Thejitterbuffercanbeconfiguredbetween2.0and16.0ms.
• Aftersettingthenewvalueyoumustevaluatetheexpected
quality.DuringtheevaluationtheTBFR(TDMBlockFailure
Ratio)barisdisplayed.YouselecteitherNext,whichper‐
formsthechangeorBacktocancelthechange.Noticethat
theJitterBufferisconfiguredpersite.