Radwin 2000 - Configuring False Radar Mitigation; Figure 19-2 False Radarm

RADWIN2000UserManual Release2.8.30 19‐5
ConfiguringFalseRadarMitigation Chapter19
ConfiguringFalseRadarMitigation
TheconfigurationmethodforthemanagedODU(ETSIandFCC/IC)isthesame.ETSI
regulationsrequirethattheover‐the‐airsitealsobeseparatelyconfiguredinthesameway.
WewilldemonstratethemethodforSiteAforalinkusingthe5.4GHzFCC/ICband:
 ToconfigureFalseRadarMitigation:
1.LogontotheMasterODUasInstaller.
2.EntertheConfigurationwindowandopentheAdvancedtab.
Figure19‐2:FalseRadarMitigation
3.TheDFSFrequencyStatusTableatthebottomofFigure19‐2showsthetime,type
andfrequencyofthelastradarsdetected.Thistableshouldbeusedtoselectthe
best option(s)toreduceoreliminatefalseradardetectionwithoutcompletely
blockingoutrealradardetection.
4.Checkthemitigationfeaturestobeused.