Radwin 2000 - Table 9-5 Telnet - Set Immediate

RADWIN2000UserManual Release2.8.30 9‐46
ConfigurationwithTelnet
displayPM
<interface:AIR,LAN1,LAN2,TDM1,
TDM2,...,TDM16>
<interval:current,day,month>
Showstheperformancemonitortablesforeach
interfaceaccordingtouserdefinedmonitoring
intervals
displaybands Displayavailablebands
displayratio Displayuplink/downlinkratio,permille
displaysyncloss_thresh Displaysync‐lossthreholdinKbps
Table9‐5:Telnet‐Setimmediatecommands
Command Explanation
setip<ipaddr><subnetMask>
<gateway>
SettheODUIPaddress,subnetmaskandgateway .
TheusermustresettheODUafterthecommand
completion
settrap<index:1‐10><ipaddr>
<port:0‐65535>
Setaspecifictrapfromthetrapstable(e.g.settrap3
10.104.2.2162)
setreadpw<oldpasswd><passwd> Setthereadaccesspassword(ReadCommunity)
setwritepw<oldpasswd><passwd>
Settheread‐writeaccesspassword(Read‐Write
Community)
settrappw<oldpasswd><passwd> SetthetrapCommunitystring
setbuzzer
<mode:0=OFF,1=ON,2=ALWAYS_ON
,3=AUTO>
Setthebuzzermode
settpc<power:Valuebetween
minimalTxpower,andmaximalTx
power>
SettheODUTxPower.Ifawrongvalueisentered,
bothminandmaxvaluesshallbedisplayedinthe
errorreply
setname<newname> Setthenameofthelink
setlocation<newlocation> Setthesitename
setcontact<newcontact> Setthenameofthelocation
setethernet
<port:MNG,LAN1,LAN2>
<mode:AUTO,10H,10F,100H,100F,D
ISABLE>
SetthemodeandspeedofeachEthernetport
setsyncloss_thresh Setsync‐lossthresholdinKbps(default1000Kbps)
Table9‐4:Telnet‐Displaycommands(Continued)
Command Explanation