Radwin 2000 - Figure 9-26 Telnet Session Log; Table 9-4 Telnet - Display

RADWIN2000UserManual Release2.8.30 9‐45
ConfigurationwithTelnet
Figure9‐26:Telnetsessionlogon
ARead‐OnlyCommunitystringallowsdisplay onlywhereasaRead‐WriteCommunitystring
allowsdisplayandsetcommands.
SupportedTelnetcommandsareshowninTable9‐6.Notethatsomeofthecommandsare
model‐specific.Forexample,TDMcommandswillnotapplytoEthernetonlyandPoEbased
links.
Table9‐4:Telnet‐Displaycommands
Command Explanation
displayinventory
DisplaysODUproductname,Name,Location,
hardwareandsoftwarerevisions,uptime,MAC
address,IDUproductname,IDUsoftwareand
hardwarerevisions
displaymanagement DisplaysIP,Subnet,Gateway,Trapstable
displaylink
DisplaysState,LinkID,ChannelBW,RSS,TSL,
Frequency/ACS,DFS,Rate/ARA,Distance
displayethernet
DisplaysBridgeMode,Agingtime,Porttable(State,
Statusandaction)
displayethernet_errors DisplayFCSerrorsforODU/IDURx,IDULAN1/LAN2
displaytdm
DisplaysClockMode,MasterClockMode,Current
Clock,Quality,TDMtable(Linestatus,ErrorBlocks)
displayntp DisplaysTime,ServerandOffset