Radwin 2000 - Figure 9-5 Configuring

RADWIN2000UserManual Release2.8.30 9‐10
ConfiguringVLANforManagement
Atanytime,clickApplytosaveaccumulatedManagementchanges.
ConfiguringVLANforManagement
VLANManagementenablesseparationofusertrafficfrommanagementtrafficwhenever
suchseparationisrequired.Itisrecommendedthatbothsidesofthelinkbeconfiguredwith
differentVLANIDsformanagementtraffic.(Thisreducesyourchancesofaccidentally locking
yourselfoutofthelink.)
 ToenableVLANmanagement:
1.ClickConfigurationfromthemainmenu.
2.Chooseasitetoconfigure.Ifyouareconfiguringbothsites,choosesiteBfirstto
avoidlockingyourselfout.
3.ChooseManagement.
4.OpentheVLANtab.
Figure9‐5:ConfiguringmanagementtrafficVLANSettings
5.ChecktheEnabledbox.
Tip
VLANIDsareusedbyRADWINproductsinthreeseparatecontexts:
ManagementVLAN,TrafficVLANandEthernetRing.Itisrecommended
thatyouusedifferentVLANIDsforeachcontext.