Radwin 2000 - Chapter 8: Configuring the Link; Overview

RADWIN2000UserManual Release2.8.30 8‐1
Chapter8:
ConfiguringtheLink
Overview
Thischapterdescribesthelink configurationprocedure,whichisperformedafterthe
installationofbothsidesoftheRADWIN2000link,assetoutinChapte r6.
LinkconfigurationusesaLinkConfigurationwizardtoredefinetheconfigurationparameters
andfine‐tuneanoperationallink.Bothsides ofthelinkareconfiguredsimultaneously.
Linkconfigurationallowsyoutoconfigurelinkparameters,whichdonotleadtosync‐lossor
requireareset.Somemaychangeserviceperformance, inrespectofwhich,warningsare
displayed.
Foreaseofuse,theLinkConfigurationwizardfollowsthesamepatternasLinkInstallation.
Youshouldthereforebe familiarwiththecontentofChapter6.
ThefollowingparametersareconfiguredusingtheLinkConfigurationWizard:
• Systemparameters
• Channelsettings
• Transmissionpowerandantennasettings
• Serviceparameters
TheConfigurationWizardhassevenstepsasshowninTable8‐1below.