Radwin 2000 - Figure 10-18 Active Alarmss; Table 10-6 Active Alarms

RADWIN2000UserManual Release2.8.30 10‐21
ActiveAlarms
alltrapmessages,otherwise.Forassociatingauserwithatrapaddress,seeConfiguringIP
AddressesforTrapDestinations.
ActiveAlarms
Uponsettingatrapdestination,applicableeventsarereportedasactivealarmstotheuser.
TheactivealarmsaresavedandcanbeviewedintheActiveAlarmswindow.
 Toviewsummaryofsavedalarms:
1.FromtheToolsmenu,chooseActiveAlarmSummary.
2.Chooseeitherofthesitesoffered.
TheActiveAlarmsSummarywindowopens:
Figure10‐18:ActiveAlarmsSummary
TheactivealarmsdisplaydoesnotupdateitselfuntiltheRefreshbuttonisused.
Thefollowingtableprovidesanexplanationofthe commandbuttons.
ViewingRecentEvents
EachODUstoresthelast256events:
Table10‐6:ActiveAlarmscommandbuttons
Command Action
Save
SavesthealarmsinCSVorte xtformatforfurtheranalysis
Refresh
Showstheactivealarmsatthemomentofrefresh
Site
Selectssitefortheactivealarms
Close
Closestheactivealarmwindow