Radwin 2000 - Disabling Qos; Figure 21-4 mir Choice - Per

RADWIN2000UserManual Release2.8.30 21‐5
DisablingQoS
5.Priorities:Youarecompletelyresponsibleforthecompletenessandconsiste ncyof
yourVLANorDiffservpriorities.
6.ChooseaMaximumInformationRateforeachqueue:
Figure21‐4:MIRchoice‐perqueue
IfyoupreviouslyusedSite|Ethernet|MaximumInformationRate(Chapter9)to
globallylimitthesite,thenyourchoiceinFigure21‐4willalsobelimited.l
7.ClickOKontheexitdialogtoacceptthesettings.Ifyoudidnotusethesesettingsfor
theoppositesite,youshouldconfigureitnow.
8.Completethewizardintheusualway.
DisablingQoS
InthedialogofFigure21‐2,choosetheDisabledmode.Thetwositesmaybeenabledor
disabledindependently.