Radwin 2000 - Table 11-3 Legend for Radio

RADWIN2000UserManual Release2.8.30 11‐5
RFP:GeneralRadioFramePattern
SelecttheRFPthatgivesyoutheBestFitorAvailableforrequiredsystemservicesandselect
thechannelbandwidthaccordingly.
RFP:GeneralRadioFramePattern
WhensettingtheRPF,thefollowingconsiderationsshouldbeborneinmind:
• SelectionoftheRFPinfluencesthecapacity,latencyandTDMquality
• RFPinfluencescapacityandlatency.Jitterbufferconfigurationcanbeusedtosetthe
TDMquality(seetheUserManual,Chapter6,TDMServicesselection)
• UsingtheLinkBudgetCalculator,youcanseetheaff ectoftheRFPontheEthernet
throughput.
RFP:RADWIN2000Considerations
• TheperformanceofRADWIN2000radiosthatoperatewithRFPsBorEcanbeseenin
theLinkBudgetCalculator.
• ForRADWIN2000Cseries:IftheHSSMasterworksinasymmetricTx/Rxratio,thenall
othercollocatedRADWIN2000unitsmustoperateinthesameTx/Rxratio.Inthiscase
theratiowillbefixedandnotautomatic‐adaptive.
• Installation/Configurationconsiderations:IfyouareusingRADWIN2000Cmasterand
RADWIN2000clients,theServicesandRatesdialogwilllooklikethis:
Table11‐3:LegendforRadioFramePatternTables
Item Description
Bestfit OptimalRFPchoiceforTDMandEthernetservices
Available AvailableRFPforTDMandEthernetservices,butnotoptima
N/A Serviceunavailable
Note
TheRFPmustbethesameforeachlinkwithinthecollocatedsystem.