Radwin 2000 - Table 9-6 Telnet - Set Commands

RADWIN2000UserManual Release2.8.30 9‐47
ConfigurationwithTelnet
resync
ResyncstheODUs.Theuseriswarnedthatthe
commandwilldropserviceforafewseconds.Theair
interfaceisresetbutnotlost.TheTelnetsessionis
maintained.(WatchtheIDULEDs.)
reboot
ResetsboththeIDUandtheODU.Theuseriswarned
thatthecommandwillresettheODU.AnewTelnet
sessiontotheODUmaybe openedaftertheresetis
complete.(WatchtheIDULEDs.)
help Displaystheavailablecommands
Table9‐6:Telnet‐Setcommandsrequiringreset
Command Explanation
set<ssid> SetLinkID
setrate<index:1‐7,adaptive>
Settherat.Indexistothetableasappearsinthe
ConfigWizard
setbridge<mode:0=Bridging 
OFF,1=BridgingON>
SettheODUbridgemode(0–off,1–on)
setratio<1‐1000> setuplink/downlinkratio,permille
setdual_tx_mode(mode:1=MIMO,
2=Diversity)
SetdualantennamodetoMIMOorDiversity
setpreferredfrequenciesclear Clearpreferredfrequencies.Requiresaresync.
setpreferredfrequenciesadd
<freq>
AddapreferredfrequencyinMHz.Requiresaresync.
Table9‐5:Telnet‐Setimmediatecommands(Continued)
Command Explanation