Radwin 2000 - Link Configuration and HSS

RADWIN2000UserManual Release2.8.30 12‐6
LinkConfigurationandHSS
LinkConfigurationandHSS
TheHubSiteSynchronizationSettingsdialogboxappearsinboththeLinkInstallationand
ConfigurationWizards.
Figure12‐6:HSSSettings:Left‐client,Right ‐master
TheSynchronizationStatusdialogboxdisplaysthecurrentstatusofeachsideofthelink.
• Operation:Typeofunit
• HubSyncMaster(HSM)
• HubSyncClient‐DisableTransmission(HSC‐DT)
• HubSyncClient‐ContinueTransmission(HSC‐CT)
• IndependentUnit
• Synchronization:
• N/A‐forMasterorIndependentUnits
• Synchronized‐forHubSiteClients
• NotSynchronized‐forHubSiteClients
Note
ContinueTransmissionisintendedtoworkifthereisnoHSMpulse.Ifa
wrongHSMpulseisdetected,aWinLink1000willresync,adaptingtothe
HSMRFPandcontinuewhereasRADWIN2000maystop.