Radwin 2000 - Figure 5-5 Log on Window; Table 5-2 User Types, Default

RADWIN2000UserManual Release2.8.30 5‐5
TheRADWINManagerlog‐onConcept
Figure5‐5:Logonwindowexposingtheusertypes.
Therearethreeusertypes:
• AnObserverhasread‐onlyaccesstothelink.AnObservercanmonitorthelink,gener‐
atereports,butmaynotchangeanylinkparameters.
• AnOperatorcaninstallandconfigurethelink.
• AnInstallercan,inadditiontofunctioningasanOperator,alsochangetheoperating
band.Thelatterfunctionhaslegalramifications,requiringfamiliaritywithlocalregula‐
tions.
IfyouareusingTrapAuthentication,entertheUserandPassword.Leavingthesefieldsblank
orincorrect,willnotpreventyoufromloggingon.Youwillnotbeabletoseetrapmessages
directedtothetrapmessageaddressassociatedwithadefineduser.Theallocationand
associationofatrap
addresswithauserisdescribedinChapter9,IPAddress,VLANand
Protocol.
IfyouareconnectingthroughtheRNMSserverchecktheRMNSconnectbuttonandenter
yourserverIPaddress.Thefollowingtablesummarizestheseoptions:
Table5‐2:Usertypes,defaultpasswordsandfunction
UserType
Default
Password
Function
SNMPv1 SNMPv3
Community
Community
String
Password
Default
Value
Observer admin Monitoring Read‐Only public Read‐Only public
Operator admin
Installation,
configuration
Read‐Write netman Read‐Write netman
Installer wireless
Operatorplus
set‐band
Read‐Write netman Read‐Write netman