Radwin 2000 - Figure 15-4 Servicesc

RADWIN2000UserManual Release2.8.30 15‐5
InstallingaRADWINMHS
5.EstablishSecondaryLinkintheusualway,withHSSenabled.Thetwolink
frequenciesshouldbeatleast5MHzapart.
6.ConnecttheMHScablesatSitesAandBasshowninFigure15‐1andFigure15‐3
above.
7.RuntheConfigurationWizardforPrimaryLink.ActivateTDMservicesintheusual
way.NavigatetotheHotStandbytab,intheServicesConfigurationpanel:
Figure15‐4:ServicesConfigurationPanel:HotStandbymodeselection
CheckthePrimarybuttontoconfigurePrimaryLinkastheprimarylink.
8.CompletetheWizard,andthenmovetoSecondaryLink.
9.Repeatstep7forSecondaryLink.FortheServicesHotStandbytab,thistime,check
theSecondarybutton.
10.CompletetheWizard.
11.AtSite1.2,reconnecttheHotStandbyPatchpaneltotheexternalequipment.
Fromthispointon,wewillsimplyrefertoprimaryandsecondarylink(nocapitalizednames).
Attheendoftheprocess,theRADWINManagermainwindowsshouldlooklikethis: