Radwin 2000 - Muting the Alignment Tone Buzzer; Configuration with Telnet; Figure 9-25 Alignment Tone

RADWIN2000UserManual Release2.8.30 9‐44
Mutingthealignmenttonebuzzer
Mutingthealignmenttonebuzzer
TheODUalignmenttonebecomesaudibleassoonaspowerissupplied,andcontinuesuntil
theODUsarealigned andthelink established.
Itispossibletomutethetoneduringregularoperationofthelink.Itmustbeenabledwhen
performingthealignmentprocedure.
 Tomutethealignmenttonebuzzer:
1.Chooseasite.TheConfigurationdialogboxopens.
2.IntheConfigurationdialogbox,clicktheBuzzerbutton.
Figure9‐25:Alignmenttonebuzzerstates
3.ClickOff.Thetoneisdisabled.
 Torestorethealignmenttonebuzzer:
1.Chooseasite.TheConfigurationdialogboxopens.
2.ClickOntohavethebuzzerbeepcontinuouslyorAutotohavethebuzzerbeeponly
ininstallmode.
ConfigurationwithTelnet
ATelnetterminalcanbeusedtoconfigureandmonitortheRADWIN2000.
TostartaTelnetsession,usetelnet<ODU_IP>.
Forexample,ifyourunTelnetasfollows,
telnet10.104.2.2
youwillbeaskedforausernameandpassword.
TheTelnetlogonusernameisthepasswordthatyouusedtoentertheRADWINManager
(forexample,thedefault:admin).TheTelnetpasswordisthecorrespondingCommunity
string(default:netman).