Ricoh MP9000 - Page 123

Interface Settings
53
2
❖ IPv6 Stateless Address Autoconfiguration
You can set “IPv6 Stateless Address Autoconfiguration” to “Active” or “Inactive”.
• Active
•Inactive
❖ DNS Configuration
Make settings for the DNS server.
When you select [Specify], enter the [DNS Server] IP address as “xxx.xxx.xxx.xxx"(“x"
indicates a number).
• Auto-Obtain (DHCP)
•Specify
• DNS Server 1: 000.000.000.000
• DNS Server 2: 000.000.000.000
• DNS Server 3: 000.000.000.000
❖ DDNS Configuration
You can specify the DDNS settings.
• Active
•Inactive
❖ Domain Name
You can specify the domain name.
• Auto-Obtain (DHCP)
•Specify
❖ WINS Configuration
You can specify the WINS server settings.
If [On] is selected, enter the [WINS Server] IP address as “xxx.xxx.xxx.xxx"(“x"
indicates a number).
If DHCP is in use, specify the [Scope ID].
Enter a [Scope ID] using up to 31 alphanumeric characters.
• On
• Primary WINS Server: 000.000.000.000
• Secondary WINS Server: 000.000.000.000
•Scope ID
•Off
❖ Effective Protocol
Select the protocol to use in the network.
•IPv4: Active / Inactive
• IPv6: Active / Inactive
•NetWare: Active / Inactive
• NetBEUI: Active / Inactive
• AppleTalk: Active / Inactive