Host Interface
167
5
Host Interface
This section describes various items of [Host Interface] under [Printer Features].
Default settings are shown in bold type.
❖ I/O Buffer
You can set the size of the I/O Buffer. Normally it is not necessary to change
this setting.
• 128KB
• 256KB
❖ I/O Timeout
You can set how many seconds the machine should wait before ending a print
job. If data from another port usually arrives in the middle of a print job, you
should increase this timeout period.
• 10 seconds
• 15 seconds
• 20 seconds
• 25 seconds
• 60 seconds
To Next Page