Ricoh MP9000 - Specifying Network Security Level

To Next Page

To Previous Page

Enhanced Network Security

130

Specifying Network Security Level

This can be specified by the network administrator.

This setting lets you change the security level to limit unauthorized access.

Set the security level to [Level 0], [Level 1], or [Level 2].

Select [Level 2] for maximum security to protect confidential information.

Select [Level 1] for moderate security. Use this setting if the machine is connected

to the office local area network (LAN).

Select [Level 0] to use this setting if no information needs to be protected.

You can specify the network security level setting for the entire network using

the machine’s control panel. However, once you change the network security

level setting using Web Image Monitor, the setting will no longer appear on the

control panel.

Reference

For details about logging on and logging off with user authentication, see p.24

“Logging on Using Administrator Authentication”, p.26 “Logging off Using

Administrator Authentication”.

A Press the {User Tools}key.

B Press [System Settings].

C Press [Administrator Tools].

BelliniC3-EN_Sec_F_FM_forPaper.book Page 130 Friday, December 16, 2005 9:16 AM