Registering Folders
213
7
I Enter the login user name, and then press [OK].
J Press [Change] under Login Password.
K Enter the password, and then press [OK].
L Enter the password again to confirm, and then press [OK].
M Press [Folder].
N Press [NCP].
O A confirmation message appeares. Press [Yes].
P Select "Connection Type".
If you want to specify a folder in an NDS tree, press [NDS]. If you want to spec-
ify a folder on a NetWare server, press [Bindery].
Q Specify the folder.
R Press [OK].
S Press [Exit].
Note
❒ To register the name, see Registering Names”.
❒ You can enter up to 64 characters for the user name.
❒ If you have set "Connection Type" to [NDS], enter the user name followed
by the name of the context where the user object is located. If the user name
is “user" and the context name is “context", enter “user.context"
❒ You can enter up to 64 characters for the password.
❒ To specify a folder, you can either enter the path manually or locate the
folder by browsing the network.
❒ When [Do not Specify] is selected, the NCP User Name and NCP Password
that you have specified in Default User Name / Password (Send) of File
Transfer settings applies. For details, see "File Transfer".
❒ If User Authentication is specified, contact your administrator.
Reference
p.184 “Registering Names”
p.214 “To locate the folder manually”
p.214 “Using Browse Network to locate the folder”
"Entering Text", About This Machine
To Next Page
Loading...