EasyManua.ls Logo

Ricoh MP9000 - Page 423

Ricoh MP9000
942 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
When a Message is Displayed
63
4
Insufficient mem-
ory. Reduce the
scanning area.
When a paper misfeed
occurs in the machine
during printing, scanning
cannot be performed.
After the misfed paper has been re-
moved, proceed with scanning.
Cannot find "XXX"
scanner used for
the previous
scan. "YYY" will
be used instead.
(“XXX” and “YYY” indi-
cate scanner names.)
The main power
switch of the previ-
ously used scanner is
not set to “On”.
The machine is not
connected to the net-
work correctly.
Check whether the main power
switch of the scanner used for the
previous scan is turned off.
Check the previously used scanner
is connected to the network correct-
ly.
Cancel the Personal Firewall of the
client computer.
Use an application such as telnet to
make sure SNMPv1 or SNMPv2 is
set as the machine’s protocol. See
“Network Settings”, General Set-
tings Guide and “Using telnet”,
Network Guide.
Select the scanner used for the pre-
vious scan.
Error has oc-
curred in the
scanner driver.
An error has occurred in
the driver.
Check whether the network cable is
connected correctly to the client
computer.
Check whether the Ethernet board
of the client computer is recognized
correctly by Windows.
Check whether the client computer
can use the TCP/IP protocol.
Communication er-
ror has occurred
on the network.
A communication error
has occurred on the net-
work.
Check whether the client computer can
use the TCP/IP protocol.
Scanner is in use
for other func-
tion. Please wait.
A function of the machine
other than the scanner
function is being used
such as the copier func-
tion.
Wait for a while and reconnect.
Insufficient
memory. Close all
other applica-
tions, then re-
start scanning.
Memory is insufficient. Close all the unnecessary applica-
tions running on the client compu-
ter.
Uninstall the TWAIN driver, and
then reinstall it after restarting the
computer.
No User Code is
registered. Con-
sult your system
administrator.
Access is restricted with
user codes.
Contact the administrator of the ma-
chine.
Message Cause Solution

Table of Contents