Authentication and its Application
62
2
P Specify the range in which [Simple (Limitation)] is applied to Printer Job Au-
thentication.
You can specify the IPv4 address range to which this setting is applied, and
whether or not to apply the setting to the parallel and USB interfaces.
Q Press [Exit].
R Press [On] for “SSL” and then press [OK].
To not use secure sockets layer (SSL) for authentication, press [Off].
S Press the {User Tools} key.
BelliniC3-EN_Sec_F_FM_forPaper.book Page 62 Friday, December 16, 2005 9:16 AM
To Next Page
Loading...