Ricoh MP9000 - Page 699

Appendix
214
8
❖ Interface
The settings available to the user depend on whether or not administrator au-
thentication has been specified.
If administrator authentication has been specified, the settings available to
the user depend on whether or not “Available Settings” has been specified.
*1
The IEEE802.11b interface unit option must be installed.
*2
The IEEE1394 interface board option must be installed.
*3
The Bluetooth interface unit option must be installed.
*4
The IEEE 1284 interface board option must be installed.
Category Settings Admin-
istrator
authen-
tica-
tion has
not
been
speci-
fied.
Administrator au-
thentication has
been specified.
“Avail
able
Set-
tings”
has
been
speci-
fied.
“Avail
able
Set-
tings”
has not
been
speci-
fied.
Change Interface ❍❍U
IEEE 802.11b
*1
Communication Mode ❍❍U
Channel ❍❍U
WEP Setting ❍❍U
WEP Key Status ❍❍U
Authentication Type ❍❍U
Key ❍❍U
Confirm Key ❍❍U
IEEE 1394
*2
IP over 1394 ❍❍U
SCSI print (SBP-2) ❍❍U
Bidirectional SCSI print ❍❍U
Bluetooth
*3
Operation Mode
❍❍U
Parallel Interface
*4
Parallel Timing ❍❍U
Parallel Communication Speed ❍❍U
Selection Signal Status ❍❍U
Input Prime ❍❍U
Bidirectional Communication ❍❍U
USB USB ❍❍U
BelliniC3-EN_Sec_F_FM_forPaper.book Page 214 Friday, December 16, 2005 9:16 AM