Connecting the Machine
20
1
Note
❒ [IEEE 1394] is displayed when optional IEEE 1394 interface board is installed.
❒ As to [Effective Protocol], check if the protocol to use is set as [Active].
❒ When setting [POP before SMTP] to [On], also make setting for [Reception Proto-
col] and [POP3/IMAP4 Settings].
❒ When setting [POP before SMTP] to [On], check [POP3] port number in [E-mail
Communication Port].
Reference
p.52 “Interface Settings”
p.62 “File Transfer”
IEEE 802.11b (wireless LAN)
This section describes necessary set items for sending e-mail with IEEE 802.11b
(wireless LAN).
For details about specifying the settings, see "Interface Settings" and "File Transfer".
File Transfer Program/Change/
Delete E-mail Message
As required
File Transfer Scanner Resend Interval Time As required
File Transfer Number of Scanner Resends As required
Heading Setting Item Setting Requirements
interface settings/Network Machine IPv4 Address Mandatory
interface settings/Network IPv4 Gateway Address Mandatory
interface settings/Network DNS Configuration As required
interface settings/Network DDNS Configuration As required
interface settings/Network Domain Name As required
interface settings/Network WINS Configuration As required
interface settings/Network Effective Protocol Mandatory
interface settings/Network LAN Type Mandatory
interface settings/Network Permit SNMPv3 Communication As required
interface settings/Network Permit SSL/TLS Communication As required
interface settings/Network Host Name As required
interface settings/
IEEE 802.11b
Communication Mode Mandatory
interface settings/
IEEE 802.11b
SSID Setting As required
interface settings/
IEEE 802.11b
Channel As required
Heading Setting Item Setting Requirements
To Next Page
Loading...