To Next Page

To Previous Page

15 February 2006 SERVICE PROGRAM MODE TABLES

5-31

Service

Tables

1103* Fusing Idling (B064)

This setting controls the length of time that the hot roller turns freely with no paper

in the fusing unit. This increases the temperature of the hot roller.

Adjusts the fusing idling time:

[0~900/1 s]

Increase this value when fusing on the 1st and 2nd copies is not completed

because of low room temperature.

1104* Fusing Temperature Control (B064)

Selects the fusing temperature control mode.

[0~1/1]

0: On/Off control

1: Phase control

If power supply to the machine is unstable, select Phase Control. The machine

must be switched off and on after this setting is changed for the new setting to take

effect.

Phase control could interfere with radio or TV reception.

1105* Fusing Temperature Adjustment

Adjusts the fusing temperature of the hot roller for plain paper, OHP or thick paper.

001 Normal Time (Center

Thermistor)

Fusing temperature during the ready condition (and

during printing for B064)

B064: [150~230/1 degree C]

B140: [180~205/1 degree C]

002 Normal Time (End

Thermistors) (B140)

Fusing temperature during the ready condition

B140: [180~205/1 degree C]

003 OHP (Center Thermistor) Fusing temperature during printing:

B064: [150~230/1 degree C]

B140: [180~205/1 degree C]

004 OHP (End Thermistor)

(B140)