15 February 2006 SERVICE PROGRAM MODE TABLES
5-41
Service
Tables
2507* ID Sen. Patt. During Job
001 Operation Setting
Determines whether an ID sensor pattern is created during copy jobs.
[0~1/1]
0: Off
1: On
002 No. of Copies
Selects the interval (number of copies) between ID sensor patterns when 1 is
selected for SP2507-001
[0~10,000/1]
2602 PTL Setting (1st /2nd Copy Side) (B140)
Turns the PTL off and on. The PTL (Pre-Transfer Lamp) decreases the charge on
the drum to make better separation of the paper from the drum, and prevents
stripper pawl marks on the leading edges of copies.
Note:
• The PTL operates only when copying with plain paper or translucent paper. It
does not operate when copying with OHP, index sheets, or thick paper.
• If blurring occurs in images at the leading edges of copies, switch SP2602-001
off (set to “0”).
001 ON/OFF Setting
(1st Copy Side)
Turns the PTL lamp on/off during transfer to the front side of
the paper at normal speed. This setting is always off when
thick paper or OHPs are fed.
[0~1/1]
0: Off
1: On
The timing can be adjusted with SP2602-002.
002 OFF Timing (1st
Copy Side)
Adjusts the length of the space from the leading edge where
PTL quenching is applied to the front side at normal speed.
For example, if you select +3, then quenching will be done 3
mm from the leading edge on the front side.
[-5~10/0.1]
003 ON/OFF Setting
(2nd Copy Side)
Turns the PTL lamp on/off during transfer to the front side of
the paper at normal speed.
[0~1/1]
0: Off
1: On
004 OFF Timing (2nd
Copy Side)
Adjusts the length of the space from the leading edge where
PTL quenching is applied to the back side at normal speed.
For example, if you select +3, then quenching will be done 3
mm from the leading edge on the back side.
[-5~10/0.1]
To Next Page
Loading...
