SERVICE PROGRAM MODE TABLES 15 February 2006
5-40
2313 Tray 3 Trans. Curr. Adj. DFU
Adjusts the current applied to the transfer belt during copying and paper feed from
Tray 3.
001 Image Leading Edge - Front [10~200/1 µA]
002 Image Trailing Edge –Front
003 Image Leading Edge – Back
004 Image Trailing Edge – Back
005 Image Leading Edge – Thick Paper [10~200/1 µA]
006 Image Trailing Edge – Thick Paper
2314 Tray 4 Trans. Curr. Adj. (Japan Only)
Adjusts the current applied to the transfer belt during copying and paper feed from
Tray 4.
001 Image Leading Edge: Front [10~200/1 µA]
002 Image Trailing Edge: Front
003 Image Leading Edge: Back
004 Image Trailing Edge: Back
005 Image Leading Edge: Thick Paper [10~200/1 µA]
006 Image Trailing Edge: Thick Paper
2315 Bypass Trans. Curr. Adj. DFU
Adjusts the current applied to the transfer belt during copying and paper feed from
the bypass tray.
001 Image Leading Edge: Front [10~200/1 µA]
002 Image Trailing Edge: Front
003 Image Leading Edge: Back
004 Image Trailing Edge: Back
005 Image Leading Edge: Thick Paper [10~200/1 µA]
006 Image Trailing Edge: Thick Paper
007 Image Leading Edge: OHP [10~200/1 µA]
008 Image Leading Edge: OHP
2506* Cont. Op. Time Cleaning Setting
001 Operation Setting
Determines whether multiple copy jobs are stopped at regular intervals for: 0)
Stopping and reversing the drum motor to clean the cleaning blade edge, and 1)
creating an ID sensor pattern to correct toner density control.
[0~1/1]
0: No
1: Yes
The interval is set with SP2506-002. Use if the drum gets dirty or images get too
pale or too dark during a long job.
002 Time Setting
Selects the interval at which multi-copy jobs are stopped.
[1~100/1 min.]
To Next Page
Loading...
