SERVICE PROGRAM MODE TABLES 15 February 2006
5-102
Delivery Server (B140/B246) 5845
These are delivery server settings.
FTP Port No. 001
[0~65535/1]
IP Address 002
Use this SP to set the Scan Router Server address. The IP address under the
transfer tab can be used with the initial system setting.
[0~FFFFFFFF/1]
Capture Server IP Address 005
Sets the IP address that is assigned to the PC that the capture server (eCabinet
or ScanRouter) operates. This IP address is set remotely when the delivery
server (Scan Router) IO device is registered. This SP only enables the IP
address permit access to the DNS browser names.
Delivery Error Display Time 006
Use this setting to set the length of time that the message is shown when a test
error occurs during document transfer with the NetFile application and an
external device.
[0~999/1]
IP Address (Secondary) 008
Sets the IP address that is given to the computer that is the secondary delivery
server for Scan Router. This SP lets you set only the IP address, and does not
refer to the DNS setting.
Delivery Server Model 009
Lets you change the model of the delivery server that is registered by the I/O
device.
[0~4/1]
0: Unknown
1: SG1 Provided
2: SG1 Package
3: SG2 Provided
4: SG2 Package
Delivery Svr. Capability 010
Changes the functions that the registered I/O device can do.
[0~255/1]
Bit7 = 1 Comment information exits
Bit6 = 1 Direct specification of mail address possible
Bit5 = 1 Mail RX confirmation setting possible
Bit4 = 1 Address book automatic update function exists
Bit3 = 1 Fax RX delivery function exists
Bit2 = 1 Sender password function exists
Bit1 = 1 Function to link MK-1 user and Sender exists
Bit0 = 1 Sender specification required (if set to 1, Bit6 is set to “0”)
Delivery Svr.Capability (Ext) 011
These settings are for future use. They will let you increase the number of
registered devices (in addition to those registered for SP5845 010).
There are eight bits (Bit 0 to Bit 7). All are unused at this time.
Delivery Server Scheme (Primary) 013
NIA 12.14