SERVICE PROGRAM MODE TABLES 15 February 2006
5-112
5860* SMTP/POP3/IMAP4 (B140/B246)
020 Partial Mail Receive Timeout
[1~168/1]
Sets the amount of time to wait before saving a mail that breaks up during
reception. The received mail is discarded if the remaining portion of the mail is not
received during this prescribed time.
021 MDN Response RFC2298 Compliance
Determines whether RFC2298 compliance is switched on for MDN reply mail.
[0~1/1]
0: No
1: Yes
022 SMTP Auth. From Field Replacement
Determines whether the FROM item of the mail header is switched to the
validated account after the SMTP server is validated.
[0~1/1]
0: No. “From” item not switched.
1: Yes. “From” item switched.
SMTP Auth Direct Sending 025
Occasionally, all SMTP certifications may fail with SP5860 006 set to "2" to
enable encryption during SMTP certification for the SMTP server. This can occur
if the SMTP server does not meet RFC standards. In such cases you can use this
SP to set the SMTP certification method directly. However, this SP can be used
only after SP5860 003 has been set to "1" (On).
Bit0: LOGIN
Bit1: PLAIN
Bit2: CRAM_MD5
Bit3: DIGEST_MD5
Bit4 to Bit 7: Not Used
5863 SMP/FTP/NCP Settings (B246)
SMB Default User Name 001
This SP sets the default user name used for SMB sending.
SMB Default Password 002
This SP sets the default password used for SMB sending.
FTP Default User Name 003
This SP sets the default user name used for FTP sending.
FTP Default Password 004
This SP sets the default password for FTP sending.
NCP Default User Name 006
This SP sets the default user name used for NCP sending.
NCP Default Password 007
This SP sets the default password for NCP sending.
To Next Page
Loading...
Need help?
General
