15 February 2006 SERVICE PROGRAM MODE TABLES
5-125
Service
Tables
6116* Staple Limit Counter for Thick Paper
Multiply the normal limit by this number to determine the staple limit number for
thick paper.
[1~3/1 sheet]
6117 Finisher Input Check Displays the signals received from sensors and switches
of the finisher. (☛ 5.6.5)
001 INPUT1
002 INPUT2
INPUT3
003
004
INPUT4
005 INPUT5
006 INPUT6
6118 Finisher Output Check Turn on the electrical components of the finisher
individually for test purposes. (☛ 5.6.6)
6118 Jogger Off/On
This SP switches the jogging operation of the output jogger attached to the side of
the finisher off and on.
[0~1/1] 0: Off, 1: On
Note: After installation of the Output Jogger Unit B703, this SP must be set to "1"
for the jogging motor to operate the jogging fences.
6119* Punch Function Enabled (Thick Paper)
Allows punching heavier paper, including tab sheets.
[0~1/1]
0: Punching thick paper prohibited
1: Punching thick paper allowed
6120* Finisher Free Run (B478/B706) (B064/B140)
Selects the free run mode during testing.
001 Free Run 1 Stapling Mode Stapling only
002 Free Run 2 All Mode All finisher operation is tested
003 Free Run 3 Packing Mode Before you move the finisher to a new location,
do this SP. When you switch on the machine
after you moved it, the finisher automatically
goes to the ready condition.
004 Free Run 4 Shift Mode Tests the shift mode
To Next Page
Loading...
