PUNCH UNIT (B531/B812) 15 February 2006
1-62
10. At the front, secure the punch unit [A] with the large step screw (" x 1, M4 x
10).
11. At the rear, position the 2 mm spacer [B] and attach the punch unit [C] (" x 2,
M4 x 10).
NOTE: At the hole just above the lock lever, use one of the screws from the
paper guide removed above to fasten the remaining two spacers to the
frame. These extra spacers are used to adjust the horizontal position of
the punch holes.
12. At the front, fasten the punch unit knob [D] (" x 1).
B531I006.WMF
B531I005.WMF
[D]
[A]
[B]
[C]
To Next Page
Loading...
