APPENDIX 1 (FOR MODEL MT) 30 May, 2002
APPENDIX-2
Machine No.12345
Jumper Set 2-3 2-3 2-3 2-3 1-2
PI device code 0 1 2 3 4
3. Re-install the upper left cover.
4. Install the core [A] and connect the modular cord to the line adapter as shown.
5. Install the line adapter (refer to chapter 2-1 L-ADP Installation Procedure in the
CSS Service Manual).
6. Turn on the machine.
When connecting only one machine to the line adapter, skips step 7.
7. Enter the Copier SP mode and set the PI device code with SP5-821 (default 0).
NOTE: After changing the value, turn the main power switch off and on to
enable the PI device code.
B064X109.WMF
Line Adapter
B064X554.WMF
[A]
To Next Page
Loading...
