15 February 2006 Z-FOLDING UNIT (B660)
1-71
Installation
6. Attach the ground plate [A] (" x 2) to the finisher (or the cover interposer tray).
NOTE: This is the ground with the flat plate attached with 2 vertical screws.
7. Open the front door of the finisher.
8. Pull out the lock lever [B] of the finisher (" x 1).
-or-
If the cover interposer tray is installed, pull out the lock lever of the cover
interposer tray.
9. Dock the Z-folding unit to the finisher.
10. Fasten the screw [B] (" x 1).
11. Fasten screw [E] to front lock bracket [F].
NOTE:
• Screw [E] is not needed if the Z-folder will be installed with a B246 Series
machine and the SR4000 B700 or SR970 B701.
• However, both brackets are required. Do not remove bracket ".
12. Fasten the rear lock bracket [D] (" x 1).
B660I013.WMF
[A]
[B]
[C]
[D]
[E]
[F]
"
To Next Page
Loading...
