Maintenance and Service
Hydraulic system
(5) Specialized tool
Using the special tool
(ROPA item no. 018139800) (5), loosen
the old filter element by aligning it cen-
trally and turning it anti-clockwise in the
direction of the "OPEN" marking (6).
Finally, pull the old filter element out
upwards.
(5) Specialized tool
(6) Rotation direction mark
Clean housing, cover and separating
plate.
Check the O-rings and the separating
plate. Replace any damaged parts.
(7) Thread of filter element
Before installation, moisten sealing sur-
faces of the new filter element, its thread
(7) and O-rings with fresh hydraulic fluid.
380 / 546
To Next Page