SATO CT4-LX User Manual

Registering Print Settings as Media Profiles (When Using Multiple Types of Media)
148
(3) Liner
Calculate the values from the following equations to input dots.
◦ 203 dpi: Label length (mm) x 8
◦ 305 dpi: Label length (mm) x 12
• This is not displayed if the optional dispenser unit or linerless cutter unit is installed.
• This is displayed if you have selected [Label] for the media type, and selected [Gap] or
[I-Mark] for the sensor type, and enabled the Label Waste Prevention function.
• You can change the units to dots, " (inches), or mm in the [System] > [Regional] >
[Unit] menu.
13.
Tap or slide the screen to the left.
14.
Adjust the print speed and the print darkness, and then tap or slide the screen
to the left.
15.
For the RFID models, tap the RFID tag format to use, and then tap or slide the
screen to the left.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz