SATO CT4-LX User Manual

33
Internal View
(1) Print head (Consumables)
Creates an image on the media. Clean the print head regularly.
(2) USB connector (Type A)
You can use USB memory to automatically back up setting information by using the auto-clone
function.
The connector is on the underside of the top cover. Pull out the parts (3), on which are
engraved, inside the top cover, remove the cover that is held by screws, and then insert the USB
memory.
• Be sure to perform a virus check on the USB memory before connecting it to the
product. SATO Corporation shall not be held responsible for any product malfunctions
caused by a virus spread via USB memory.

SATO CT4-LX Specifications

General

Print Method	Thermal Transfer / Direct Thermal
Print Resolution	203 dpi
Max Print Width	4.09 inches (104 mm)
Media Type	Roll, Fan-fold
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Ribbon Width	0.98 inches (25 mm) to 4.09 inches (104 mm)
Ribbon Length	984 feet
Connectivity	USB, Ethernet, Bluetooth
Supported Barcode Types	PDF417, QR Code
Power Requirements	100-240 VAC, 50/60 Hz