85
9. Tap the sensor type for detecting the media.
[None]
Disable the media sensor.
[Gap]
Select when using the media of Gap type. Use the transmissive sensor.
[I-Mark]
Select when using the media of I-mark type. Use the reflective sensor.
• The available selections vary depending on the [Print Mode] set on the product. The
initial value of [Print Mode] differs depending on the options installed on the product.
◦ If [Print Mode] is set to [Dispenser], only [Gap] and [I-Mark] will be available.
◦ If [Print Mode] is set to [Linerless cutter] or [Linerless tearoff], only [None] and [I-
Mark] will be available.
10. Load the media and ribbon while checking the video.
Tapping the icon starts playing the video.
To Next Page
Loading...
