Shimadzu GC-2014 Instruction Manual

16 Special Functions
16.6 GC Configuration
243
GC-2014
16.6.7.5 Selecting the flow signal
Select the signal type from the main screen and then press “FLOW” to display the
screen shown in Fig. 16.6.9.
Select the flow signal to be output.
Select the carrier gas, detector gas and APC gas items. The APC gas can be set when
the APC is installed as an option in any location other than the flow controller or the
detector gas.
Q Carrier gas
If you select the carrier gas for the flow signal selection, the screen shown in Fig. 16.6.9 appears.
Q Detector gas
If you select the detector gas for the flow signal selection, the screen shown in Fig. 16.6.10
appears.
Fig. 16.6.9 Carrier gas signal setup screen
Fig. 16.6.10 Detector gas signal setup screen
Select an item to be output
from each area.
The currently set channel No.
is displayed.
Select an item to be output
from each area.
The currently set channel No.
is displayed.

Shimadzu GC-2014 Specifications

General

Type	Gas Chromatograph
Display	LCD
Maximum Heating Rate	120°C/min
Data Acquisition	Digital
Maximum Number of Detectors	4
Weight	Approx. 45 kg
Carrier Gas	Helium, Nitrogen, Hydrogen
Detector Options	FID, TCD, ECD, FPD
Injection Port	Split/Splitless, On-column
Gas Control	Electronic Flow Control (EFC)
Temperature Programming Rate	0.1 to 120 °C/min
Power Requirements	230 V AC, 50/60 Hz
Detector Temperature Range	Up to 400°C (depending on detector type)