For SYNTH1 type patterns, a step has attributes that determine PITCH, GATE, VELOCITY
(ACCENT), GATE LENGTH (SLIDE), REPEAT and DELAY, in addition to ACTIVE for the
entire step.
For SYNTH2 type patterns, a step has attributes that determine PITCH, GATE, VELOCITY
(ACCENT), and REPEAT, in addition to ACTIVE for the entire step.
"
"
Defines the pitches of the step
The velocity of the note to be played, accent is a
quick way to set the velocity to a preset value
Defines the note length, slide is created when a
note overlaps the next note, also known as legato.
This is interpreted by most 303 clones as a “slide”
The step type can be a step, tie or rest. The total
length of a note is determined by the combination
of a step event along with subsequent tie events
Determines if the step will be played or skipped
Activates the note repeat effect for the step
Delays the start of the note.
Defines the note pitches for the step
The velocity of the note which is limited to the fixed
velocities defined in TRACK UTILITY mode.
Defines the note length, can be defined
independently per note
The step type can be a step, tie or rest. The total
length of a note is determined by the combination
of a step event along with subsequent tie events
Determines if the step will be played or skipped
Activates the note repeat effect for the step
To Next Page
Loading...