Social Entropy Engine - Page 22

BASICS
For DRUM type patterns, a step has attributes that determine TRIGGER, VELOCITY and
REPEAT for sixteen drum instruments, in addition to ACTIVE and DELAY for the entire step.
In a CONTROL type pattern, a step has attributes that determine the CONTROL VALUE ,
SLIDE and CONTROL ACTIVE state for the six control knobs, in addition to ACTIVE state
for the entire step.
TRIGGER
1-16
Defines which drum instruments will
be played on this step
VELOCITY
1-16
The trigger velocity per drum
instrument. Available velocities are
set in TRACK UTILITY mode.
ACTIVE
Determines if the step will be played
or skipped
REPEAT
1-16
Activates the note repeat effect for
the step
DELAY
Delays the start of all triggers
CONTROL
VALUE 1-6
Defines the control value that will be sent for one
of the six controllers
CONTROL
ACTIVE 1-6
Determines if the controller value will be sent for
this step
SLIDE 1-6
Determines if the (optional) CV slide is engaged,
also will send intermediate MIDI CC to next step.
ACTIVE
Determines if the step will be played or skipped
 USER GUIDE 11