OnAir 3000 Digital Mixing Console
Operation 5-99
Document generated: 10.10.14
SW V6.0
5.7.5 Snapshot Operation Details
For general snapshot operation please refer to chapter 5.3.6.
The available snapshot operations depend on the current selection within the
local snapshot list:
Selected Item >> << Rename Delete
Global
–
Creates a new global
snapshot
(Administrator only)
– –
Any Global Snapshot
Recalls the selected
snapshot
Overwrites the selected
global snapshot
(Administrator only)
Renames the selected
global snapshot
(Administrator only)
Deletes the selected
global snapshot
(Administrator only)
User Name
– – – –
Default
–
Creates a new default
snapshot,
or
Overwrites the default
snapshot
– –
The Default Snapshot
Recalls the default snap-
shot
Overwrites the default
snapshot
–
Deletes the default snap-
shot
Private
–
Creates a new private
snapshot
– –
Any Private Snapshot
Recalls the selected
snapshot
Overwrites the selected
private snapshot
Renames the selected
private snapshot
Deletes the selected pri-
vate snapshot
The <<, >>, Rename, and Delete buttons are only visible if the correspond-
ing operation is allowed.
‘Recall’ Loads the selected snapshot parameters into the console.
‘Overwrite’ Updates the selected snapshot parameters within the selected snapshot. Un-
selected parameter files remain unchanged.
A dialog box ‘Snapshot ‘name’ already exists. Do you want to overwrite
it?’ pops up. When answering Yes, all selected parameter files will be over-
written.
‘Create’ Creates a new snapshot and saves the selected snapshot parameter files. The
keyboard appears for entering a snapshot name; a generic name (such as New
Snap) is automatically suggested.
If a name is entered of which at least one snapshot file (audio, input/output
routing, assign) already exists, a dialog box ‘Snapshot ‘name’ already
exists. Do you want to overwrite it?’ pops up. When answering Yes, all
selected parameter files will be overwritten.
‘Rename’ Renames all snapshot parameter files of the selected snapshot. The snapshot
parameter selection buttons (audio, input/output routing, assign) are ignored
in order to be consistent.
If a name is entered that already exists for at least one snapshot file, a dialog
box ‘Snapshot ‘name’ already exists. Do you want to overwrite it?’ pops
up. When answering Yes, all selected parameter files will be overwritten.
‘Delete’ Deletes the selected parameters of the selected snapshot. A dialog box ‘Do
you really want to delete the selected snapshot parameters’ pops up.
When answering Yes, all selected parameter files will be deleted.
To Next Page
Loading...
