Studer OnAir 3000 - Channel Screen; Desk Resource Definition; Logical Inputs

7-10 A/B Desk Configuration
OnAir 3000 Digital Mixing Console
Document generated: 10.10.14
SW V6.0
7.4.2 Channel Screen
container.ini
Configure the ContainerIDs of the ChannelScreens as follows:
  • 110... for the primary desk
  • 160... for the secondary desk
The ChannelScreen will also consider the StripChannel/DeskResource Defi-
nition (e.g. a ChannelScreen with ID# 160 indicates the first six StripChan-
nels of the secondary desk).
7.4.3 Desk Resource Definition
Configuration Tool: UserGUIPrimaryDesk→ Desk Resources
Configuration Tool: UserGUISecondaryDesk→ Desk Resources
The SCore resources have to be assigned either to the primary or the second-
ary desk, according to AB DESK Mode Desk Resources.xls.
Please note that:
  • StripChannel,
  • MonitoringCR/ST1andST2/ST3,and
  • InputGroup
must match the XML configuration of the desks, as described in chapter 7.4.1.
Note: It may be helpful to set the Label of the first LogicalInput and the first
LogicalOutput of the secondary desk before defining the Desk Resources
‘LogicalInput’ and ‘LogicalOutput’.
7.4.4 Logical Inputs
Configuration Tool: Config → LogicalInputs
The following parameters have to be configured according to AB DESK
Mode IO Config.xls:
  • Alias
  • Label
  • Location
  • First/SecondRouterSource
Note: If a mic input is shared between the primary and the secondary desk, both
LogicalInputs must have the same Location.