OnAir 3000 Digital Mixing Console
5-152 Operation
Document generated: 10.10.14
SW V6.0
5.12.4.9 Routing
Error Code Error Type Error Text / Comment
6000
Warning
Routing failure. The routing of channel 2 on Container100 could not be changed. Channel 2 on Con-
tainer100 is virtual.
6001
Warning Pending Routing. The routing of channel 2 on Container100 is not yet changed. Input Digi1 is on-air.
6002
Warning
Routing failure. The routing of channel 2 on Container100 could not be changed. Channel 1 on Con-
tainer100 is locked.
Appears if the strip assignment of a locked channel strip shall be changed. This can be caused by loading
a snapshot or when deselecting a source via MONITORA.
6003
Warning
Routing failure. Inexistent Input (#17) cannot be assigned to channel. No Input assigned to channel 2 on
Container100.
6004
Warning
Routing failure. Not enough DSP channels.
Input “DVD 5.1” cannot be assigned to channel 2 on Container100.
Appears when trying to assign a LogicalInput to a strip that needs more DSP channels than physically
available. (Input routing change and Snapshot recall).
6102
Warning
Routing failure. The source of output PGM Out on Container100 could not be changed. The output is
locked.
Appears while changing the output routing and the corresponding Logical Output is locked.
5.12.4.10 Option Manager
Error Code Error Type Error Text / Comment
7100
Info
LICENSE Manager, System identification has changed. Please enter new license key. Optional software
will stop working in 15 days.
Appears after power-up and once each day if the MAC address has been changed until 15 days after the
MAC address has been changed.
7101
Info
LICENSE Manager, License key was changed. Core and desk(s) must be restarted to take effect of the
change.
Appears if a license key has been changed in the ConfigGUI.
7102
Warning
LICENSE Manager, System identification has changed since more than 15 days. Please enter new license
key. Optional software is now disabled.
Appears after power-up if the license key has not been changed during 15 days after the MAC address has
been changed.
7103
Warning
LICENSE Manager, License keys cannot be loaded. Incompatible license file version in ‘fileName’. Optional
software is not enabled.
Appears if the option manager extension cannot open the license key (.key) file because of the wrong
snapshot version.
Appears once each day, after 15 days after the MAC address has been changed.
7104
Warning
LICENSE Manager, System identification has changed since more than 15 days. Please enter new license
key(s). Optional software will be disabled after the next CORE restart.
Appears once each day, after 15 days after the MAC address has been changed.
5.12.4.11 CAB Extension
Error Code Error Type Error Text / Comment
8001
Warning CAB, Broadcast Automation disconnected.
8100
Warning CAB (Monitora protocol), SELECT_SOURCE failed: No free stripchannel.
8101
Warning
CAB (Monitora protocol), SET_SAS_INPUTROUTING failed: HD-Link signal ID out of range. InputLine can-
not be routed.»
Appears on reception of a SET_SAS_INPUTROUTING message if at least one of the required HD Link
Ins is out of range (e.g. the required HD Link In for right surround channel is 97 but only one DSP Card is
installed).
To Next Page
Loading...
Need help?
General
