Studer OnAir 3000 - Desk Groups; Inputs; Inserts; Monitoring Rotary Source Selector

7-12 A/B Desk Configuration
OnAir 3000 Digital Mixing Console
Document generated: 10.10.14
SW V6.0
7.4.6.3 Desk Groups
Configuration Tool: Config → Selections → Desk Grps
  Usually,theprimarydeskisDeskGroup1,andthesecondarydeskisDesk
Group 2.
Notes: Only input groups containing LogicalInputs of the primary desk have to be
added to the desk group of the primary desk (Desk Group 1). The same applies
to the secondary desk.
Desk Groups configuration must match the Desk_ModuleTable.xml
file; refer to chapter 7.4.1.
7.4.6.4 Inputs
Configuration Tool: Config → Selections → Inputs
The Input Routing list must contain all Input Groups that should be visible
in the input or output routing pages of both the primary and the secondary
desk.
7.4.6.5 Outputs
Configuration Tool: Config → Selections → Outputs
The Logical Outputs list must contain all Logical outputs that should be vis-
ible as output routing targets in the output routing pages of both the primary
and the secondary desk.
7.4.6.6 Inserts
Configuration Tool: Config → Selections → Inserts
The Insert Points list must contain all Input Groups that should be visible for
insert assigment in the insert pages of both the primary and the secondary
desk.
7.4.6.7 Monitoring Rotary Source Selector
Configuration Tool: Monitoring → Rotary
The internal signals selectable by the monitoring rotary source selector are
specified here, such as CR or ST1 monitoring sources are specified here.
Note: Only signals related to the corresponding desk should be added to the corre-
sponding selection, e.g. PGM A must not be added to the Monitoring Rotary
Source Selector ST1 list if it is not used on the secondary desk.