OnAir 3000 Digital Mixing Console
Operation 5-23
Document generated: 10.10.14
SW V6.0
Test Generator Functions
For test purposes, the OnAir 3000 features an internal test signal generator
available for every channel. While the generator is active, the normal channel
buttons in the left part of the page are disabled and displayed in gray. The
test generator may only be activated by users having the appropriate access
rights configured by the system administrator. Waveform, frequency and level
settings are performed on the Admin - Gen page (see chapter 5.3.7.8).
Note: Activating the test generator temporarily switches the cannel input from the
assigned source signal to the generator’s output. Channel settings, such as EQ,
dynamics, etc. are not affected, which allows setting the channel parameters
to the desired values using the test generator.
GEN Generator on/off button; this button is highlighted when the generator is
active.
L, R The format (mono or stereo) of the test generator output follows the current
channel output format.
The L and R buttons route the generator output to the left and/or right chan-
nel and are not displayed for mono input channels. For 5.1 channel surround
inputs, there are six channel selection buttons, as shown below.
To Next Page
Loading...
Need help?
General
