6. GUI orientation
Or,
click in the “x” on the right hand side in the destination configu ration list.
Image 6-29
destination(s) is immediately outlined in red.
3. The deletion is completed by clicking the Delete Selected button.
Any ou tput can b e deleted from a destination at any time. For example, if the output that is automatically
assigned to a destination is not the desired one, then it can b e deleted.
All destinations can be deleted the same time by clicking the “Select All” button.
How to access to the Destination configurat ion adjustments
Adjustments to Destinations a re performed in the “Adjust” panel:
1. Select the des tination from the configuration list
Or,
clicking o n the grap hic representation the destination in the Diagram area.
A Destination is selected.
2. Click on the Adjust tab that is on the top of the Adjustment area.
Image 6-30
The Destination adjustment panel is displayed.
Destination adjustment panel description
The Destination adjustment panel is divided in three sections:
R5905948 E2 12/12/2014
101
To Next Page
Loading...
Need help?
General
