CAPINTEC, INC. CAPTUS
®
3000
Figure 6-10
9. Next, the screen appears as shown in Figure 6-11, prompting you to measure the isotope
selected for efficiency measurement.
Figure 6-11
To measure the isotope, place the isotope standard in the Probe or Well as the message
indicates and click the
button. Data collection begins as shown in Figure 6-10
above. To stop the measurement, click the
button. The screen then appears
as shown in Figure 6-12.
Figure 6-12
Click the button or press the Y key to end the procedure. The screen appears
as shown in Figure 6-8. Click the
button to start again or click the
button to quit.
6-8 ISOTOPES November 13
To Next Page
Loading...
