Loading show files
Spark
10-3
Loading show files
The Load menu, menu 2, manages loading show files stored on the hard disk and the
floppy disk.
Entering this function automatically activates the disk drive, which reads and displays the
files stored on the diskette.
Keypresses Results/Comments
1. Insert diskette with the
show files to the disk
drive.
2. Go to menu 2. The diskette contents are displayed.
3. Press F1 Play/Act #
The console prompts for a show file number.
4. Enter the desired show file
on the numeric keypad.
If you have made an error in entering the play
number, the message "
BAD PLAY NUMBER"
appears. Start again and enter the correct play
number.
5. Press F1 All diskette
The message
Are you sure?
is displayed.
6. Press F1 Yes
A
Wait
message is displayed. After load is
complete the Memory List is displayed. If the
show file does not contain memories the
message reads
No Memories Loaded.
¾
¾
Note
If there are memories on board during load, the memory numbers in the file that are
identical to the memories already on board do not load.
Load options
You may choose to load only portions of the show file. This is a very versatile function,
saving much editing time by allowing different shows to share a common patch or mix
output, transferring libraries and macros from show to show, etc.
The different options are:
F1 All
All of the data contained in the show file is loaded.
F2 Patch Only
Load the patch tables only. Patch tables include Spot
Patch, Channel Patch (including the DMX Input
Patch), and Scroller Patch.
F5 Macro Only
Load only the macros.
F6 F1 Library Only
Choosing this option allows loading
F1
All Libraries,
F2
Position Libraries,
F3
Gobo Libraries, or
F4
Color
Libraries.
F6 F2 Mix Device
Only
Load the mix device table only. Note that only the
device table is loaded and not any patch assignments
or output addresses.
¾
¾
Note