EasyManuals Logo

Compulite Spark User Manual

Compulite Spark
276 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #46 background imageLoading...
Page #46 background image
Releasing a Channel from the Editor
Spark
5-5
Example: Assign 73% intensity to channel 5.
Keypresses Results/Comments
1. Press [CHANNEL]
Skip this step if the numeric selection default
is channel
2. Select 5 on the numeric
keypad.
3. Press [@].
Int
appears in the command line after the
channel selection and channel 5 is displayed
in red.
4. Press [7] [•] [3]
If the system is defined as
USA, press [7] and [3].
73 is displayed under the channel number on
the channel display.
Repeating an intensity assignment
You can repeat the last intensity assignment.
Example: assign 33% to channel 1 and repeat the level assignment to the next channel you
select. In the example below the intensity on channel 1 is repeated for channel 8.
Keypresses Results/Comments
1. Select channel 1.
2. Assign intensity level at 33%
using the dimmer wheel.
You can also assign the level on the numeric
keypad.
3. Select channel 8.
4. Press [•] (dot)
33% intensity is assigned to channel 8.
Releasing a Channel from the Editor
Select channels and remove them from the editor. The channel/s can be bumped out or
faded out.
Keypresses Results/Comments
1. Select the channel.
2. Press [RELEASE]
The channel faders down. When it reaches
0% it is released from the editor.
Keypresses Results/Comments
1. Select the channel.
2. Press [ERASE]
The channel bumps out.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Compulite Spark and is the answer not in the manual?

Compulite Spark Specifications

General IconGeneral
BrandCompulite
ModelSpark
CategoryController
LanguageEnglish