Releasing Spots/Parameters
Spark
6-15
Releasing Spots/Parameters
Releasing a spot from the editor
While editing spots for memory programming, you might want to release a spot or a
parameter of a spot from the editor so it will not be included in the memory.
Keypresses Results/Comments
1. Select the spot
number.
A group or a range of spots can be selected.
2. Press [RELEASE]
The spot is released and its parameter values revert
to tracking or the values output from a playback
device.
Releasing a parameter from the editor
Note that if you release a parameter from the editor and then continue to record a memory,
the released parameter is included in the memory if the dimmer of the spot is on and the
Store tracking if dimmer On function is active. The Store tracking if dimmer On is
disabled in the System Parameters menu.
Keypresses Results/Comments
1. Select spots
2. Select the parameter by
pressing the SK parameter key.
3. Press [RELEASE]
The parameter values revert to tracking or
the values output from a playback device.
To Next Page
Loading...
Need help?
General