Adding a Part to a Memory
Spark
15-6
Adding a Part to a Memory
New channels and spots can be added as Parts to stored memories.
In the example below, part 3 consisting of parameter 2 spot 5 is added to the last recorded
memory.
Keypresses Results/Comments
1. Select spot 5.
2. Select parameter 2.
3. Assign a value to parameter
2.
4. Press [MEMORY]
If no memory number is entered, the part is
added to the last recorded memory. To add
this part to another memory, enter a memory
number at this point.
5. Press [PART] and enter 3 on
the numeric keypad.
6. Assign a fade time.
7. Press [STORE]
The message
Memory 1 Stored
is displayed.
¾
¾
Note
If the Part exists the message Part Exists is displayed. Press
[CLEAR]
to cancel or press
[STORE]
to overwrite the Part.
Modifying a Part
You can select one part of a memory for modification. When modifying a part, only the
channels/spots in the selected part are live.
Example: Modify memory 1 by changing the intensity of channel 8 in part 5.
Keypresses Results/Comments
1. Select memory 1.
2. Select part 5
3. Select channel 8. The part is in the editor and channel 8 is
selected.
4. Press
[@]
and enter 6 on the
numeric keypad.
60% intensity is assigned to channel 8.
5. Press
[STORE]
The message
Memory 1 Stored
is displayed.