Adding Text to Snaps
Spark
17-3
Adding Text to Snaps
Text labels can be attached to snaps.
Keypresses Results/Comments
1. Press [SNAP]
Snap
is displayed in the command line.
2. Enter the Snap number on
the numeric keypad.
3. Press [TEXT]
4. Type the text on the
alphanumeric keypad.
5. Press [STORE]
Text for Snaps is displayed in all Snap exams.
The first 5 characters are displayed on the
Controller display in Soft Key Snap mode
Examining Snaps
There are 2 Snap Exams. The Snap List is a list of all the Snaps with their text labels.
Selected Snap Exams show all the playback device assignments stored in the Snap and
their run modes.
Viewing the snap list
Keypresses Results/Comments
1. Press [SNAP]
Snap
is displayed in the command line.
2. Press [EXAM]
A list of the snaps and any textual notes is
displayed. This is a strong Exam display.
Examining a selected Snap
Keypresses Results/Comments
1. Press [SNAP]
Snap
is displayed in the command line.
2. Select the snap on the
numeric keypad
3. Press [EXAM]
All information for the selected snap is displayed.
4. Press [+] or [-] to exam
the next or previous Snap.